Technogym Run Excite 900 - Troubleshooting Common Issues; Equipment Not Switching On; Noise and Irregular Sounds

32
Run
cont.
Troubleshooting
Below is a list of problems that may arise during normal use of the equipment. If the described remedies do not solve the
problem, contact the Technical Support Service.
Problem Cause
Remedy
Equipment doesn’t
switch on
Mains power failure.
Check the power supply at the wall socket used by the equipment by plugging in an appliance
that definitely works.
The Circuit breaker is open.
Check that the two keys next to the switch are closed, by pressing them fully down.
Power supply cable damaged
Contact the Technogym Technical Support Service.
The control panel connector has been accidentally disconnected.
Contact the Technogym Technical Support Service.
Too noisy
Equipment not properly levelled.
Check the position and level with the rear adjustment foot.
Damaged bearings.
Contact the Technogym Technical Support Service.
Worn belt.
Contact the Technogym Technical Support Service.
Irregular noise from
motor area
Treadmill not centrally aligned.
Align the treadmill as described in Aligning the treadmill section.