05156025
37
Run
Switching on and off
To turn the equipment off, switch the main switch to the “OFF” position (0).
The ON (I) / OFF (0) positions may vary according to the equipment version.
The correct positions are given on the label on the equipment.
The equipment must be switched off only at the end of the exercise, when in
standby.
If the equipment isn’t going to be used for a long time, as well as turning it off
you should also pull the plug out of the wall socket.
Warning
The switch is for turning the equipment on and off but does
not isolate it completely from the mains voltage, even in the
“OFF” (0) position. For complete isolation you must unplug
the power supply plug.
To Next Page
Loading...
