7.8 REPLACING THE
PLATFORM
7.8.1 REPLACING THE SLATS
1. Remove the individual slats using the
long, articulated T-handle wrench.
WARNING: tighten the screws with a
torque wrench set to 1.25Nm (1 lbf-ft).
CAUTION: the maximum number of
slats that can be removed is 13.
7.8.2 REPLACING THE FRONT
ROLLER
Disassemble the front right guard and the front
left guard.
Disassemble 4 slats as indicated in paragraph
“7.8.1 Replacing the slats”.
1. Loosen the grub screws locking the bear-
ing on the right side and on the left side of
the shaft.
2. Loosen the grub screws locking the pulley
on the right side and on the left side of the
shaft.
3. Remove the nuts locking the right bearing.
4. Remove the screws.
5. Remove the ange.
6. Remove the snap ring on the left side.
To remove the shaft, align the two keys
in the shaft with the holes present on the
pulleys.
7. Proceed with shaft removal.
The shaft must be removed from the right
rubber hammer.
8. Remove the left pulley.
9. Remove the right pulley.
10. Completely remove the shaft.
11. Check the state of wear of the key.
-
12. Move the pulleys up against the respec-
tive snap rings.
13. Tighten the grub screws locking the pul-
leys.
14. Complete the reassembly.
Before tightening the grub screws lock-
ing the bearings, check that there is no
noise. If necessary, move the shaft to the
right or to the left to change the position
slightly.
Skillmill
Technical Service Guide - Rev. 2.2
Page 62
To Next Page
Loading...
