www.tecnaonline.com - info@tecnaonline.com
ENGLISH
PAR DESCRIPTION
8.3 INFORMATION REGARDING THE MODE OF OPERATION
•
Always position the tool perpendicular to the surface to be broken.
FIGURE 14: Positioning the tool perpendicularly
FIGURE 15: Vibrations
•
Avoid minor irregularities on the surface to be broken when positioning the tool.
•
Put correct pressure with the jib. Vibrations can be transferred to the support frame, which
can cause damage to the support frame, in case of too low or too high pressure of the jib on
the hydraulic breaker.
•
Avoid strokes without load since it may damage the hydraulic breaker.
•
Do not use the hydraulic breaker as a ripper or break lever.
OPERATING MANUAL - Hydraulic breakers T series
28
/
44
REV
0.0
OPERATION
8
To Next Page
Loading...
