www.tecnaonline.com - info@tecnaonline.com
ENGLISH
PAR DESCRIPTION
8.3 INFORMATION REGARDING THE MODE OF OPERATION
•
Do not operate the hydraulic breaker in case of fully lowered hydraulic cylinders at the jib.
•
Ensure that the support frame (jib, hydraulic lines among other things) is not touched or
damaged when moving the hydraulic breaker.
•
Do not use the hydraulic breaker as a transportation device including the lugs.
•
Do not use the hydraulic breaker as a clearing device to remove material from the operating range.
•
Work very carefully for the first 15 minutes at temperatures below 0 °C so that the tool can heat up
slowly. The tool should not be heated more than necessary, e.g. with a welding torch.
•
According to the Technical Details of the dealer or authorised Service, change the nitrogen filling
pressure if the hydraulic oil temperature is constantly above 70 °C.
•
Always keep the hydraulic breaker vertical if it is idle or is not used for a long time so as to avoid
damage to seals for instance. Do not ram the hydraulic breaker into the ground.
FIGURE 18: Perpendicular position due to upside-down position
FIGURE 19: Hydraulic breaker is not a lifting tool
OPERATING MANUAL - Hydraulic breakers T series
30
/
44
REV
0.0
OPERATION
8
To Next Page
Loading...
