Tecnam P2010 2015 - Page 219

4.3 LANDING GEAR TIRES PRESSURE CONTROL
For each wheel proceed as follows:
I. Remove wheel fairing
2. Unscrew the tire cap
3. Connect a gauge
4. Read the pressure value
5. If required, rectify the pressure (nose tire 2.2 Bar I 32 psi, main landing
gear tires 2.5 Bar/ 36 psi)
6. Fit the tire cap
7. Install wheel fairing
36 psi
2.5 bar
32 psi
2.2 bar
FIG. 8·2. TIRE PRESSURE PLACARDS
2"d Edition, Rev. 0
Section 8 - GROUND HANDLING & SERVICE
MAINTENANCE