Tecnam P2012 - Oil System

P2012
AIRCRAFT MAINTENANCE MANUAL
proiper installation. Check actuator and position indicator for proper
electrical connections.
57-00 Wings Inspect ailerons control rods for condition and security. Inspect ailerons
bellcranks for condition and security of installation. Check the torque
seal. Check stops for looseness and effectiveness.
X
57-00 Wings Visually inspect lubber lines on wings attaching points. In case of
retorquing or replacement (bolt/nut) Re-apply torque seal.
X
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
EXHAUST
78-00 Exhaust Visually inspect exhaust manifold for condition and security of
installation. Check surrounding area for burning marks and gas
leaks marks
X
78-00 Exhaust Visually inspect turbocharger overboard exhaust pipe for condition,
welding cracks and security of installation. Check for proper torque
of clamp connecting the muffler to wastegate. In case of
abnormalities (i.e. traces of fumes in the V-Clamp area) proceed
with the following inspection task.
X
78-00 Exhaust Remove V-Clamps (both on turbine and wastegate sides) and
inspect V-band segments for cracks. Inspect exhaust welded flanges
for cracks or distortion.
X
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
OIL SYSTEM
79-00 Oil System Visually inspect oil lines for condition and security of installation
X
79-00 Oil System Visually inspect oil radiator and hoses for condition and security of
installation
X
79-00 Oil System Visually inspect the oil radiator support for condition and security of
installation
X
79-00 Oil System Visually inspect the cranckcase breather and vent system including
air/oil separator for condition and security of installation
X
79-00 Oil System Clean the cranckcase breather vent outlet on the exhaust overboard
with pipe cleaner brush to avoid obstruction. (If MOD2012/140 is
installed) (Refer to ATA )
X
79-00 Oil System Oil separator and internal coalescing screen inspection and cleaning
X
05-20-00
Page 14
5
th
Edition - Rev. 0
2022, Jan 14