Tecnam P2012 - Lubrication Chart; Landing Gear

P2012
AIRCRAFT MAINTENANCE MANUAL
Table 2 - Scheduled Maintenance Tasks
NOTE:
(*) This inspection task must be applied each 100FH/1 year for compliance to 14
CFR 43 - Appendix D
(**) the inspection tasks reported in this interval must be applied each 100FH/1 year
for compliance to 14 CFR 43 - Appendix D
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
LUBRICATION CHART
05-00 Lubrication
points
Perform lubrication tasks: Refer to ATA 05-30-00. For lubrication
Charts and related frequencies.
X
05-00 Lubrication
points
Perform components lubrication tasks as per related components
Refer to ATA
Chapter 05-30
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
INSPECTION CAPS
06-00 Inspection
caps
Before installing the caps removed for maintenance purposes,
inspect for absence of loose tools, especially in correspondence of
the controls. Then make sure all inspection caps are installed and
secured
Each Activity
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
LANDING GEAR
32-00 Landing
gear
Visually inspect nose and main gear attachments, bolts and
bushings for condition and security. Check especially for cracks,
corrosion and damaged surface protection. Inspect for condition,
security and excessive play
X
32-10
32-20
Landing
gear
Visually check NLG and MLG for damage/deformation. Visually
check NLG and MLG shock absorbers for proper extension and
evidence or fluid leakage and scratches
X
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
LANDING GEAR
32-10 Landing gear Check MLG and NLG shock struts pressure (refer to
X
05-20-00
Page 4
5
th
Edition - Rev. 0
2022, Jan 14