Tecnam P2012 - Equipment and Furnishing

P2012
AIRCRAFT MAINTENANCE MANUAL
24-00 Electrical
System
Inspect circuit breakers panel and switches for general condition
X
24-00 Electrical
System
Inspect Connector Assembly LH and RH for condition and proper
installation.
X
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
ELECTRICAL POWER
24-00 Electrical
System
Inspect cockpit switches for general condition and security of installation,
damaged System electrical component and operation.
X
24-00 Electrical
System
Remove all inspection caps and inspect all electrical, wires, connectors
and attaching parts for security, routing, chafing, deterioration, wear and
correct installation. Pay particular attention behind instrument panel and
behind interior covers/panels/roof.
X
24-00 Electrical
System
Inspect Alternator for general condition, security of installation and
evidence of heat or arcing.
X
24-00 Electrical
System
Check bus bars for general condition, cleanliness, and Electrical security
of all attachments and terminals/absence of System corrosion.
X
ATA Aircraft Zone Maintenance Task Frequency
A B C D E
EQUIPMENT AND FURNISHING
25-00 Equipment
and
furnishing
Inspect seats for condition and security of installation, inspect the
seat guide and seat guide attachments for unusual furnishings wear.
X
(*)
25-00 Equipment
and
furnishing
Inspect safety belts for condition and security installation,
attachments and mouting hardware.
X
(*)
25-00 Equipment
and
furnishing
ELT inspection according to CMM
Annually Ref.
CMM
Kannad
Installation
-
Operation Manual
DOC 08038F
or
DOC 09078E
25-00 Equipment
and
furnishing
Visually inspect cargo net and the floor attachment points for
condition and security of installation.
X
(*)
25-00 Equipment
and
furnishing
First aid kit inspection for completeness and security. Verify expiry
date. Refer to local regulation for the applicability of the Task.
X
05-20-00
Page 17
5
th
Edition - Rev. 0
2022, Jan 14