P2012
AIRCRAFT MAINTENANCE MANUAL
Zone A B C D E
FUSELAGE
53-00 Cabin Visual inspect external skins, bulkheads, frames and rivets for
damage and sealing. Inspect drainage holes for obstructions,
corrosion and security.
X
(**)
53-00 Cabin Visual inspect both the front and rear wing attachments fittings on
fuselage frames structure for integrity, corrosion, condition and
security.
X
53-00 Cabin Visual inspect floor beams, panels and seat rails for damages,
corrosion, condition and security.
X
53-00 Cabin/Tail Inspect fuselage tail skin, frame and stringer for damage, crack and
wear, (Refer to ATA ).
X
(*)
53-00 Cabin/Tail Inspect rear baggage compartment skin (external and internal),
frames, stringers and net attachments for condition and security.
X(*)
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
PLACARDS
11-00 Placards
and
markings
Inspect internal placards, check for their presence, readability and
wear refer to ATA 11-30-00
X
11-00 Placards
and
markings
Inspect external placards and Aircraft data plate: check for presence,
readability and wear ATA
X
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
NACELLES
71-10 Nacelles Check RH and LH nacelles for condition of the fasteners, cracks
deformation, burned areas. Check the integrity of fireproof coating
(internal side of engine cowlings). Repaint if necessary. Clean from oil
and remove residuals from inlets.
X
71-10 Nacelles Check integrity of engine firewall. Check for cracks, Distortion or
wrinkles.
X
NOTE
: If MOD2012/018 is installed, in addition to previous maintenance tasks, check Composite Air duct of oil
cooler for integrity and correct installation
ATA Aircraft
Zone
Maintenance Task Frequency
A B C D E
FIRE PROTECTION
26-00 Fire Inspect fire detector system for damage and security of installation.
X
05-20-00
Page 10
5
th
Edition - Rev. 0
2022, Jan 14
To Next Page
Loading...
