Tecnam P2012 - Page 62

P2012
AIRCRAFT MAINTENANCE MANUAL
Table 2 - Scheduled Maintenance Tasks
NOTE:
(*) This inspection task must be applied each 100FH/1 year for compliance to 14 CFR 43
- Appendix D
(**) the inspection tasks reported in this interval must be applied each 100FH/1 year for
compliance to 14 CFR 43 - Appendix D
ATA Item Maintenance Task Frequency
A B C D E
LUBRICATION CHART
05-00 Lubrication
points
Perform lubrication tasks: refer to ATA Chapter 05-30. For lubrication
Charts and related frequencies.
X
05-00 Lubrication
points
Perform components lubrication tasks as per related components
Refer to ATA
Chapter 05-30
ATA Item Maintenance Task Frequency
A B C D E
INSPECTION CAPS
06-00 Inspection
caps
Before installing the caps removed for maintenance purposes,
inspect for absence of loose tools, especially in correspondence
of the controls. Then make sure all inspection caps are installed
and secured
ATA Item Maintenance Task Frequency
A B C D E
LANDING GEAR
32-00 Landing gear Visually inspect nose and main gear attachments, bolts and
bushings for condition and security. Check especially for cracks,
corrosion and damaged surface protection. Inspect for
looseness, condition and security of mounting points
X
32-10
32-20
Landing gear Visually check NLG and MLG for damage/deformation (ref to
ATA 51-30). Visually check NLG and MLG shock absorbers for
proper extension and evidence or fluid leakage and scratches
X
32-10
32-20
Landing gear Check MLG and NLG shock struts pressure (refer to procedure
included in ATA 32)
X
32-10
32-20
Landing gear Check MLG and NLG for excessive plays
X
32-10
32-20
Landing gear Visually inspection and cleaning MLG
X
05-20-00
Page 24
5
th
Edition - Rev. 0
2022, Jan 14