Carlcare Technical Training
TECNO_L9_Service Manual_V1.0
12. DISASSEMBLY AND ASSEMBLY HINTS
1. The two torx screws only can be unscrewed by this
type of screwdriver as shown.
2. When assembling the Battery cover, you must
following these steps.
Step 1: Press the side with earpiece of the phone.
Step 2: Check whether the Screen and Battery cover
are buckled completely.
Step 3: Press the other side of the phone as shown
until the phone is buckled completely.
3. The Battery cover of T and SIM card slot areas are
not so strong, be careful when disassemble. If it is
deformed, the holder will not be inserted again.
To Next Page
Loading...
