Tecnowind EAGLE - Safety Precautions

Safety precautions
- 4 -
Before connecting the model to the electricity
network:
- Control the data plate (positioned inside the appliance)
to ascertain that the voltage and power correspond to
the network and the socket is suitable. If in doubt ask
a qualied electrician.
- If the power supply cable is damaged, it must be re-
placed with another cable or a special assembly, which
may be obtained direct from the manufacturer or from
the Technical Assistance Centre.
- This device must be connected to the supply network
through either a plug fused 3A or hardwired to a 2 fase
spur protected by 3A fuse.
WARNING !
In certain circumstances electrical appliances may
be a danger hazard.
A) Do not check the status of the filters while the
cooker hood is operating
B) Do not touch bulbs or adjacent areas, during or
straight after prolonged use of the lighting instal-
lation.
C) Flambè (Flamed) cooking is prohibited under-
neath the cooker hood
D) Avoid free flame, as it is damaging for the filters
and a fire hazard
E) Constantly check food frying to avoid that the
overheated oil may become a fire hazard
F) Disconnect the electrical plug prior to any main-
tenance.
G) This appliance is not intended for use by young
children or infirm persons without supervision
H) Young children should be supervised to ensure
they do not play with the appliance
I) There shall be adequate ventilation of the room
when the rangehood is used at the same time as
appliances burning gas or other fuels
L) There is a risk of fire if cleaning is not carried out
in accordance with the instructions
M) Please use a private plug receptacle for power
plug.
: It might set a fire.
N) Please don’t operate the hood when taking fire
on the dishes or frying pan.
: It might set a fire.
O) Please don’t touch the product or operate the
switch with wet hands.
: You might get a shock of electricity.
P) Please don’t wipe off the hood with the chemi-
cals when cleaning.
This appliance conforms to the European Directive
EC/2002/96, Waste Electrical and Electronic Equip-
ment (WEEE). By making sure that this appliance is
disposed of in a suitable manner, the user is helping
to prevent potential damage to the environment or to
public health.
The symbol on the product or on the accompa-
nying paperwork indicates that the appliance
should not be treated as domestic waste, but
should be delivered to a suitable electric and elec-
tronic appliance recycling collection point. Follow lo-
cal guidelines when disposing of waste. For more in-
formation on the treatment, re-use and recycling of
this product, please contact your local authority, do-
mestic waste collection service or the shop where the
appliance was purchased.
Assembly and electrical connections must be car-
ried out by specialised personnel.
• Electric Connection
The appliance has been manufactured as a class II,
therefore no earth cable is necessary.
The connection to the mains is carried out as follows:
BROWN = L line
BLUE = N neutral
If not provided, connect a plug for the electrical load
indicated on the description label. Where a plug is
provided, the cooker hood must be installed in order
that the plug is easily accessible. An omnipolar switch
with a minimum opening of 3mm between contacts,
in line with the electrical load and local standards,
must be placed between the appliance and the net-
work in the case of direct connection to the electrical
network.
Before proceeding with the assembly operations, re-
move the anti-grease filter(s) so that the unit is easier
to handle. In the case of assembly of the appliance in
the suction version prepare the hole for evacuation of
the air.
• We recommend the use of an air exhaust tube which
has the same diameter as the air exhaust outlet hole.
If a pipe with a smaller diameter is used, the efficiency
of the product may be reduced and its operation may
become noisier.