- 13 -
Installation
Fixing the appliance to a wall 8.1
Phase 1
Phase 2
Before starting to fix the hood, disconnect the anti-grease
filter for easier appliance handing. Before this operation, perform
the following steps:
Phase 1
- Pull handle as shown in the picture and remove the anti-grease
filter.
Phase 2
- Check the distance between the surface which carries the co-
oking utensils on the cooking device and the bottom surface of
the cooker hood, which must be not less than 650 mm. Mark the
position of the lower side of the hood on the wall.
650 mm
CAUTION!
Wear gloves during the installation of the product otherwise injury at ngers could happen by sharp edges.
To Next Page
Loading...
