TECO JSMA-PLC08AB User Manual

41
Address
Parameter
Name & Function Default Unit
Setting
Range
RS232 RS485
Cn027 Reserve
─ ─ ─ ─
Cn028
Reserve
─ ─ ─ ─
Reset parameters.
Setting Explanation
0 Disabled
★
Cn029
1 Reset all Parameters to default ( Factory setting)
0 X
0
│
1
5FDH 001DH
Servo motor model code
★
Cn030
Servo model code can be display and checked with parameter
dn-08, refer 3-2-2 dn-08 table for more information.
Attention：Before operate your servo motor., check this param
eter
setting is compatible for servo drive and motor. If there has any
incompatible problem contact supplier for more information.
Default X X 50BH 001EH
Cooling fan running modes
(Available for JSDEP-50 & JSDEP-75)
Setting Explanation
0 Auto-run by internal temperature sensor.
1 Run when Servo ON
2 Always Running.
Cn031
3 Disabled.
0 X
0
│
3
Low Voltage Protection(AL-01) auto-reset selection
This parameter(AL-01) could be set the method of Low Voltage
Protection.
Setting Explanation
0
As servo on, it shows AL-01 low voltage alarm
immediately when it detect low voltage, and after
eliminating the situation, to reset it, servo off is a must.
Cn031.1
1
It shows BB(baseblock) immediately when it detect low
voltage
, and after eliminating the situation, drive would be
auto-reset and displayed Run.
0 X
0
│
1
50EH 001FH
Speed feed back smoothing filter
Cn032
Restrain sharp vibration noise by the setting and this filter also
delay the time of servo response.
500 Hz
1
│
2500
546H 0020H
Speed Feed-forward smoothing filter
Cn033
Smooth the speed feed-forward command.
500 Hz
1
│
1000
51EH 0021H
Torque command smoothing filter
Cn034
Restrain sharp vibration noise by the setting and this filter delay
the time of servo response.
500 Hz
0
│
5000
C17H 0022H

TECO JSMA-PLC08AB Specifications

General

Brand	TECO
Model	JSMA-PLC08AB
Category	Servo Drives
Language	English