Chapter 3 Program Tools 57
(7) PASSWORD (setting password)
Now Press
SEL
1. Begin to input numeral
2. When the password is ON, it will not display 0000, but ****.
‘SEL’ then ‘←/→’
Move the cursor
‘SEL’ then ‘↑/ ↓’
Data changed 0~F
OK Save the input data, not 0000 or FFFF, as the PASSWORD is ON.
ESC
1. Cancel the Input Data when press ‘SEL’.
2. Back to Main Menu.
※ A Class: Password number is set to 0001~9FFF.
B Class: Password number is set to A000~FFFE.
Password number = 0000 or FFFF is disabled Password function, Default setting: 0000.
If there are H coils(HMI coils) enable, A/B Class password have same access right; If there are no H coils enable,
A/B password have different access right. A/B Class password Description:
No H coil ON
H coil ON
Menu A Class B Class A Class B Class
LADDER √ √ √
FUN.BLOCK √ √ √
FBD √ √ √
PARAMETER √ √
RUN/STOP √ √
DATA REGISTER √ √
CLEAR PROG. √ √ √
WRITE √ √ √
READ √ √ √
SET √ √
RTC SET
※ ※
ANALOG SET √ √
LANGUAGE √ √
INITIAL √ √ √
√: cannot accessed under password protecting
※:SEL+OK to enter RTC SET
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
