TECO SG2 Series - Page 21

Chapter 3 Program Tools 19
Start
un are and the following Start screen will be displayed. From this screen,
you ing functions
Ne
nvironment for a new Ladder
program.
Open Existing File
Select File -->Open to choose the
type of file to open (Ladder or
FBD), and choose the desired
program file, and then click Open.
The L
testing ram select
File-- odel of SG2, and the number of connected expansion
units if
Screen
R the SG2 Client softw
can perform the follow
w Ladder Program
Select File -->New -->New LAD
to enter the development
e
program.
New FBD Program
Select File -->New -->New FBD
to enter the development
environment for a new FBD
unction Block Diagram) (F
Ladder Logic Programming Environment
adder Logic Programming Environment includes all the functions for programming and
the SG2 using the Ladder Logic programming language. To begin a new prog
>New--> and select the desired m
applicable, as shown below.