TECO SG2 Series - Quick Start Setup

Quick Start Setup 4
Quick Start Setup
This section is a simple 5-steps guide to connecting, programming and operating your
new SG2 smart relay. This is not intended to be the complete instructions for
programming and installation of your system. Many steps refer to other sections in the
manual for more detailed information.
1. Install SG2 Client Software
Install the SG2 Client Software from CD or from the free internet download at
www.taian-technology.com
2. Connect Power to SG2 smart relay
Connect power to the Smart Relay using the below wiring diagrams for AC or DC supply
for the applicable models. See “Chapter 2: Installation” for complete wiring and installation
instructions
AC ..V
NL
DC ..V
+ -