TECO SG2 Series - High Speed Counter Function Block

Chapter 5 FBD Programming 84
(4) Counter Mode 4
Counting Input
→
Up/Down Counting
→
Reset
→
Counting Parameter
→
(5) Counter Mode 5
Counting Input
→
Up/Down Counting
→
Reset
→
Counting Parameter
→
Note:The “C”means that will keep the current value in 0 during the Reset pin be enable.
(6) Counter Mode 6
Counting Input
→
Up/Down Counting
→
Reset
→
Counting Parameter
→
High Speed Counter Function Block
(1) Counter Mode 7
High counting input
→
Enable Input
→
Reset
→
Counter Parameter
→
Note ：High speed input terminal I1,I2
(2) Counter Mode 8
High counting input
→
Enable Input
→
Reset
Counter Parameter
→
Note ：High speed input terminal I1,I2