Chapter 3 Program Tools 23
b. Select the correct Com Port number where the programming cable is connected to the
computer then press the “Link” button.
c. The SG2 Client software will then begin to detect the connected smart relay to complete it’s
connection as shown below.
Writing Program to smart relay
From the Operation menu, select the Write function and write the program to the connected
smart relay as shown below.
Operation menu
line
bugging a program.
Run-Stop-Quit – Mode change selections for both runtime editing and simulation mode.
ading and writing programs to and from a connected smart relay.
Password – Set a password for accessing the current program after upload t art relay
Language – Change software language
Module System Set – Dialog for changing important system setup functions including Module ID,
Remote I/O preferences, Expansion I/O settings, and Retentive memory preferences (Keeping)
for (C) Counters, (M) Auxiliary Coils, and (Z) keypad input set and the LCD Backlight.
The Operation menu, includes several system configuration functions for both online and off
setup. The following explains the details of each function.
Monitor – Online function for runtime monitor and editing when connected to a controller
Simulator – Offline function for testing and de
Read-Write – Re
RTC Set – Online function for setup of the Real-time clock/calendar (see dialog below left)
Analog Set – setup analog input A1-A8 gain and offset (see dialog below right)
o the sm
To Next Page
Loading...
