TECO SG2 Series - Page 30

Chapter 3 Program Tools 28
( 2 ) The Main Menu as SG2 und R N’ Mode. er ‘ U
>
LADDER
FUN.BLOCK
STOP
WRITE
RTC SET
WRITE
PASSWORD
LANGUAGE
Press the Button
↑ ↓
Move the Cursor to select Main Menu
OK Confirm the selected Function
ESC Skip to Initial Screen
※SG2 can be modified, edited, cleared and read user program only when it is under STOP Mode.
s modified, SG2 will autom
the Button
ript
※As the program i atically backup it to EEPROM. (Not PM05)
◎ Main Menu LADDER
Press
Button Desc ion
SEL
1. Ix ⇒ ix ⇒ ── ⇒ spa
o r digital and character position of ,3,5 column.)
⇒ ⇒ x (only for digital and character position of 8 column.).
l v ila le u th 2 ,6 o m of the first line)
┴ ┴ x Dg l ~
ce ⇒ Ix
( nly fo 1
2. Qx space Q
3. ┬ ⇒ Space⇒ ┬ (a l a a b b t e ,4 c lu n
: i ita: 1 F
SEL +↑/ ↓
1. 1...F, ─ (When the cursor lo tes the digital s io , the ran of d al is restricted by
R ⇔ G ⇔
n the cursor cat 5 o m ).
⇔ M ⇔ T ⇔
n
⇔ ( h ur r o te at 7 o m , and the 8 Column is
set as Q, Y, M)
5. ( ⇔ P ⇔ ( (When the cursor located at 7 Column n is set as T)
ca po it n ge igit
the relay type.
2. I ⇔ X ⇔ Z ⇔Q ⇔ Y⇔ M ⇔ D ⇔ T ⇔ C ⇔ I
(Whe
3. Q ⇔ Y
lo ed at 1
C ⇔ R
,3, C
G
lu n
⇔ ⇔H ⇔ L ⇔P ⇔ Q
(When the cursor located at 8 Colum
4. ( ⇔ ¿ ⇔ À ⇔ P
)
(W en the c so l ca d C lu n
, and the 8 Colum
SEL + /← →
Confirm the input data and move the cursor
↑/ ↓
Vertically move the cursor
←/ →
Horizontally move the cursor
DEL Delete an instruction
ESC 1. Cancel the Instruction or n n er d io .
Menu after ry h p g m
actio u d E it n
2. Back to Main que t e ro ra .
OK 1. Confirm the data and autom ic ll v t n t put position.
2. When the cursor is on Column 8, Press the button to automatically enter the function
block and set the parameters(such as T/C)。
at a y save, the cursor mo es o ex in
SEL+DEL Delete a Line of Instruction.
SEL+ESC
Display the number of i t o OP) the Lines and operat on sta e f SG2 (RUN/ST 。
SEL+↑/ ↓
Skip up/ down every 4-line program.
SEL+OK Insert a space line