Betriebsanleitung/Operating manual
EGS80X002001
30 BD_BE 987 b www.tecsis.de
6 Editing device data
6.1 Parameterisation mode
A change in device data will change the operation of the device!
Before entering new data into the device, you should therefore
ascertain that no danger to the installation will result.
6.1.1 Invocation
You can return to display mode from any point in the parameterisation
mode menu by pressing the ESC key (possibly more than once).
If 10 minutes elapse without a key being pressed in configuration
mode, the device switches automatically back to display mode.
To Next Page
Loading...