Betriebsanleitung/Operating manual
EGS80X002001
www.tecsis.de BD_BE 987 b 31
6.1.2 Password
You can protect the current configuration from unauthorized changes by
using a password (see section 6.6; inactive when EGS80 delivered).
If password protection is active, the various settings in parameterisation
mode are visible before entry of the password, but may not be changed.
The first time an attempt is made to change a setting, the device
automatically displays a window for entering the password.
You must enter the password once each time after switching from
display mode to parameterisation mode.
The password cannot be changed and is 1234.
The password is entered as follows:
* If you press the or key, the value changes step by step. If
you hold the or key down, the value rolls to higher or lower
values.
To Next Page
Loading...