Betriebsanleitung/Operating manual
EGS80X002001
40 BD_BE 987 b www.tecsis.de
6.4.4 Delay
If you set a time > 0 sec, you prevent short-time violations of the trip
value from triggering an alarm.
• The relay only switches if the trip point is exceeded/fallen short of for a
period that is longer than the delay time.
• The relay only switches back if the trip point -/+ hysteresis is fallen
short of/exceeded for a period that is longer than the delay time.
• If the trip point is exceeded/fallen short of for a short time, this does
not have any effects.
The following diagram shows the operating behaviour for the trip mode
Max, operating mode Active.
To Next Page
Loading...