CONTENTS
Page 2
Wiring Diagram and Key Functions Page 3
Quick Setup and Calibration using Weights Page 4
1. Enable Zero Button / Calibrate Zero point Page 8
2. Setup and calibrate the Span Function / Display Input Signal in mV/V Page 10
3. Setup the Display (Over/Under Range Limits, steps size & decimal point, Logic I/O Status) Page 12
4. Filter Setting and No Motion Page 14
5. Analogue Output (4-20mA) Settings Page 16
6. Logic Inputs 1,2&3 Page 17
7. Logic Outputs 1,2&3 Page 19
8. Data Communication Settings Page 20
Error Codes / Return to Factory Settings Page 21
Communication Protocol Page 22
Examples
Calibration Procedure using weights Page 23
Calibration Procedure from known load cell mV/V sensitivities - Multiple active load cells Page 24
Single active load cell plus pivot Page 25
Programmers manual Annex A
Quick Setup and Calibration using the load cell mV/V Sensitivities Page 6
Filter Setting Tables & Update Rates (Number of Readings Averaged) Page 15
To Next Page
Loading...