Programmer`s manual
EZE30
www.tecsis.de BE 948 a Annex A Page 11
The bitmapped characters are:
First Bit Second Bit
value description value description
1 Not used. 1 No motion.
2 Output 1 active. 2 Zero action performed.
4 Output 2 active. 4 Tare active.
8 Output 3 active. 8 Not used.
The checksum is derived as follows:
a. Add the ASCII values (in hex) of all the 15 characters in the string
b. Invert the hexadecimal value
c. Add one to the value
d. Use only the last two digits
e. Convert the hexadecimal value to characters
3.4 AUTO-TRANSMIT COMMANDS – SG, SN, SW
The following command provide the means to output the weight results in a continuous stream, which starts upon the issue
of the relevant command, and ends upon the issue of any other command.
SG Auto-transmit the gross weight value - continually returns the current gross weight value. Issuing the SG command,
which has no parameters, will continually return the gross weight value in the format G+01.100 , until interrupted by any
other command.
To Next Page
Loading...