Programmer`s manual
EZE30
Annex A Page 22 BE 948 a www.tecsis.de
3.12 SAVE SET-UP PARAMETERS COMMAND – WP, SS, AS
The configuration parameters can be considered as four distinct groups, namely:
Calibration Parameters (CZ, AZ, CG, AG, CM, CI, DS, DP, ZT);
Indicator Parameters (FL, FM, UR, NR, NT, BR, AD, DX);
Set-point Parameters (S1, S2, S3, H1, H2, H3, A1, A2, A3);
Analog Parameters (AL, AH, AA);
The alteration and amendment of the calibration parameters is subject to the control procedure that is described in section
save commands WP, SS and AS.
WP -up parameters - ), the -
NT) and the communication settings (AD, BR, DX) in the EEPROM.
SS -up parameters -
o
saved to EEPROM
AS analogue-up parameters - saves the settings of the analogue output (AL, AH, AA) in the EEPROM
To Next Page
Loading...