Do you have a question about the TECSYSTEM NT579 and is the answer not in the manual?
Frequency | 50/60 Hz |
---|---|
Operating temperature | -20°C to 60°C |
Humidity | 90% non-condensing |
Serial port | RS485 Modbus RTU |
Input Voltage | 24 VDC |
Protection Class | IP20 |
Storage temperature | -20..+70 °C |
Inputs | Voltage 0..10V, Current 0/4..20mA |
Sampling rate | 1 sample/second |
Display | LCD 2 lines x 16 characters |
Current Consumption | 10 W |
Rated power supply voltage range.
Details on sensors, Modbus RTU, and relay outputs.
Compliance, electrical, environmental, and physical test data.
Unit display features and data handling capabilities.
Panel mounting instructions and power supply notes.
Wiring for output relays and fan control.
Wiring and signal transfer cable requirements.
Fault detection (Fcc, Foc, Fcd) and reset procedures.
Handling Ech and Cal errors.
Alarm/trip activation and fan control logic.
Using HFn for periodic fan self-testing.
Cycling through SCAN, AUTO, MAN, T.MAX modes.
Checking programmed values and navigating menus.
Entering programming and testing LEDs.
Silencing alarms and precautions during insulation testing.
Threshold settings and data storage for remote operations.
Step-by-step guide for configuring unit parameters.
Setting address, baud rate, and parity.
Overview of Modbus module and operational requirements.
Description of front panel controls and indicators.
RS485 wiring and data transmission methods.
Format of data frames in Modbus communication.
Format of Modbus requests and responses.
Supported function codes and exception error types.
Method for CRC calculation in Modbus.
Definitions of Modbus parameters.
Request/response format for writing registers.
Dynamic monitoring for fast temperature changes.
Adjusting sensitivity and managing FCD faults.
Diagram for connecting PT100 sensors.
Wiring for relays, fan, and power supply.
Connection for RS485 digital output.
Product warranty terms and conditions.
Symbol and instructions for environmentally sound disposal.