TeeJet Technologies RADION 8140 - Page 12

8
www.teejet.com
Radion 8140 automatic sprayer control
SETTINGS MENU STRUCTURE
| | | |
Job parameters Machine OEM Diagnostics
Application rate number Filling Sensor presence Test inputs Application rate Actual content Flow sensor Implement wheel sensor Nozzle type *Full tank Liquid pressure sensor Tractor wheel sensor
Density type Fill ow sensor Supply voltage Density factor Tank sensor Flow sensor
Implement speed sensor Desired content Implement parameters Fill ow sensor
Calibration number Automatic lling Number of sections Liquid pressure sensor Automatic calibration Operation Circulation Tank level sensor
*Flow sensor Application rate step Section conguration Valve setup Remote master signal
Calibration number Speed source Section number Regulation valve type Master switch Low ow limit Simulate speed Number of tips Section valve type Section switches High ow limit Minimum speed Copy section Section valve behaviour Test outputs Automatic calibration Implement parameters Section width Tank setup Liquid valve PWM duty cycle
*Liquid pressure sensor Calibrations Nozzle preset setup Maximum tank content Master valve
No pressure Alarms Nozzle preset Minimum tank content Fill valve
No pressure calibration Minimum tank content Nozzle series Automatic lling Section number
Maximum pressure Flow/pressure cross check Nozzle capacity Automatic lling offset Section valve state
Maximum pressure Section output low Factory settings Regulation details All sections off Reference pressure Low pressure limit Minimum regulation pressure Test boompilot Automatic calibration High pressure limit Maximum regulation pressure Connection
*Fill ow sensor Reference ow Regulation valve time Mode
Calibration number Reference pressure Minimum regulation voltage Section input Automatic calibration Regulation parameters Regulation deadband Alarm log
*Tank level sensor Course value calibration Regulation valve capacity Save alarm log
Empty tank Fine value calibration Regulation start delay
Automatic calibration Nozzle spacing Manual regulation speed
Minimum tank level Regulation mode Restrictor plate ow
Minimal tank level Clear totals Automatic calibration Area counter
Maximum tank level Volume counter
Maximum tank level Time counter Automatic calibration Clear all total counters Tank shape Import/export calibrations
Maximum tank level
Start calibration Import/export calibrations
OEM menu is password protected. *Menu settings directly related to fitted OEM equipment.