Teeter L5 - Page 10

8
STEP
3
Attach Handles to A-Frame
• Locate the Contour Stretch
™
Assembly Hardware Kit (HK1012).
• With the open end of each handle pointing away from the A-Frame
feet, place each Handle fitting over the A-Frame legs, aligning with
the pre-drilled holes (Figure 9).
• Insert the bolts from the inside and secure with the nuts on the
outside, tightening with the Allen Wrenches provided (Figure 10).
The Contour L5 is shown here. Your actual model may vary.
FIGURE 9
FIGURE 10