14
To clean the lid seal
• After each use, clean the seal (G) and its
housing.
• Wash the seal using a sponge and
washing-up liquid.
• To put the seal back in place, see Fig. 13
and make sure that the inscription «face
côté couvercle » is against the lid.
To clean the control module
and the valves
• Remove the control module from the lid: see
the paragraph "Control module".
• Wash the module using washing-up liquid and
then rinse under running water.
• Check visually and in plain daylight that the
steam release outlet (A) is not blocked, see
Fig.14. If it is, run it under water.
• Check that the operating valve (P) located
inside the lid can be moved, by setting the
position selector to 1 or and depressing
it with your finger: - Fig. 15.
• You can clean this valve under running water.
• Also check the correct operation of the safety
valve (Q) by pressing hard, using a cotton bud
(for example), on the central part of the duct,
which should move: see Fig. 16. You can
clean this valve under running water.
• Check that the module seal is correctly
positioned (O). If this seal is missing or
damaged, leaks may appear below the
module when you use your pressure cooker.
The shape of the seal allows its easy removal
and refitting. If necessary, you can obtain this
part from TEFAL Approved Service Centres.
• Check the cleanliness of the pressure indicator
(D); you can clean it under running water.
Never open the
control module.
Don't forget to
remove the timer.
Never put the
control module in
the dishwasher.
Do not use a sharp
or pointed object
to carry out this
operation.
Never wash the seal in the
dishwasher.
To Next Page
Loading...
Need help?
General
