Teka HLC 847 SC User Manual

5
EN
When plugging the oven in for the first time,
the logo will appear followed by 12:00
flashing on the screen.
You must set the time in order to use the
oven.
To do this select the hour with the left control
and the minutes with the right one.
Confirm the settings by pressing the
button or waiting a few seconds.
Confirm the time appearance (standard/retro/
hide the clock) by pressing the button or
waiting a few seconds.
An audible signal will be heard confirming that
the time has been set on the screen.
To change the time:
With the oven in standby (start screen), hold
the button until the time begins to flash.
Follow the previous steps to change the time.
WATER HARDNESS
 After setting the clock, you need to set the
water hardness.
 The Water Hardness option appears on
the display.
 To change the option rotate the right
control.
 Press to confirm the option.
 If you wish to modify the water hardness,
after the first settings, rotate the left
control to the position corresponding to
the Steam function .
 Rotate the right control until the Water
hardness symbol appears on the right
side of the display.
 Press to confirm the option,
 Rotate the right control to select the
desired water hardness.
 Press to confirm.
Type
Water hardness
Ca + Mg
(ppm)
English
deg. [°eH]
French deg.
[°dF]
German
deg. [°dH]
SOFT
0 to 150
0 to 11
0 to 15
0 to 8
MED
151 to 350
12 to 25
16 to 35
9 to 20
HARD
351 to 500
26 to 35
36 to 50
21 to 28
SHOWROOM MODE
With the DEMO mode activated, you can
control the oven without heating. Activating
this mode is recommended if the oven is to
be plugged in at a showroom.
Activating DEMO mode
Press the buttons and simultaneously
on the programing mode, until Mode
on the screen.
Then, set the time on the oven.
on the panel and the oven will work as normal,
but without heating up.
To deactivate DEMO mode, repeat the
same process.
The sensitivity of the touch keys adapts
continually to environmental conditions.
Make sure the surface of the control panel
is clean and free of obstacles when
plugging in the oven.
If the display does not respond correctly
when you touch the keys, unplug the oven
for a few seconds and then plug it in
again. Doing this causes the sensors to
adjust automatically so that they will react
once more to fingertip control.
In the event of power failure, the water
hardness settings will be erased. Reset it
and program again after power restore.

Teka HLC 847 SC Specifications

General

Brand	Teka
Model	HLC 847 SC
Category	Oven
Language	English