Teknatool NOVA - Page 10

119-0811-001 10
5. Put Control panel back to the on the Headstock and screw in its
three mounting screws. Check that the control panel is secure and
tighten mounting screws as necessary.
6. Power on your DVR and select the Wireless Remote in the Menu.
7. Select “Pair ID” on the screen to begin pairing procedures.
8. Press the <OFF> key on the remote to pair to the lathe, your
DVR lathe and remote should now be paired.
Note: If the remote still does not pair, please contact your local
Teknatool Agent.
.