Teknatool NOVA - Installation Instructions

119-0811-001 8
Installation Instructions:
1. Unpack the two parts from
packaging. The small circuit
board is the ‘Receiver
Module’ which goes in the
control panel of the wood
lathe. The larger device is
the ‘Remote’.
Receiver Module (C):
Remote:
2. Turn off the wood lathe and unplug its power cord. Wait 2
minutes for the control circuitry to power down.
3. Remove the Control Panel
from the headstock by
loosening or removing the
3 screws on the front of the
Control Panel. Gently
remove the Control Panel
from the head stock.