1. FOR YOUR OWN SAFETY, READ THE MANUAL BEFORE
OPERATING THE TOOL. Learn the machine’s application,
limitations and the specific hazards particular to it.
2. ALWAYS USE A FULL FACE SHIELD. Strongly recommended.
(Must comply with ANSI STANDARD Z87.1 -USA) Everyday eye-
glasses usually are only impact resistant and safety glasses only
protect eyes. A full face shield will protect the eyes and face. Also
use face or dust mask if cutting operation is dusty.
3. WEAR PROPER APPAREL. Do not wear loose clothing, gloves,
neckties, rings, bracelets or other jewelry which may get caught in
moving parts. Non-slip footwear is recommended. Wear protective
hair covering to contain long hair.
4. USE EAR PROTECTORS. Use ear plugs or muffs for any period of
operation. Use muffs rated to 103 DBA LEQ (8 hour).
5. DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use power
tools in damp or wet locations, or expose them to rain. Keep work
area well lighted. The DVR Wood Lathe is intended for indoor use
only. Failure to do so may void the warranty.
6. KEEP WORK AREA CLEAN. Cluttered areas and benches invite
accidents. Build-up of sawdust is a fire hazard.
7. KEEP CHILDREN AND VISITORS AWAY. The Nova DVR is not
recommended for children or the infirm. Such personnel and
onlookers should be kept at a safe distance from the work area.
8. MAKE WORKSHOP CHILDPROOF. Utilize locks, master switches,
or by removing starter/lockout keys.
9. GROUND ALL TOOLS. If the tool is equipped with a three-prong
plug, it should be plugged into a three hole electrical receptacle. If an
adapter is used to accommodate a two prong receptacle, the
adapter plug must be attached to a known ground. NEVER remove
the third or grounding prong.
10. DISCONNECT TOOLS. Ensure the plug is removed from the wall
socket before servicing and when changing accessories such as
blades, bits, cutters and fuses, etc.
11. AVOID ACCIDENTAL STARTING. Make sure switch is in the Off
position before plugging in power cord into the wall socket.
To Next Page
Loading...
