Tektronix 2205

Preparation for Use
INITIAL START-UP
Up to now, you should have made the following preparation:
1. Read the safety information.
2. Verified that the LINE VOLTAGE SELECTOR is set for the
source voltage to be used.
3. Verified the fuse.
4. Attached the power cord.
5. Ensured adequate ventilation around the instrument.
6. Plugged the power cord into the appropriate power source
outlet.
Now turn on your oscilloscope by pressing in the POWER button.
Observe that the Power-On indicator, located below the button,
illuminates.
2205 Operator’s
1-5