Need help?Do you have a question about the Tektronix 2212 and is the answer not in the manual?
General| Type | Oscilloscope |
|---|---|
| Bandwidth | 100 MHz |
| Channels | 2 |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Max Input Voltage | 400 V (DC + Peak AC) |
| Input Impedance | 1 MΩ |
| Display | CRT |
Defines terms and symbols used in manuals and on equipment for safety communication.
Details essential precautions to ensure personal safety and prevent equipment damage.
Explains controls for the oscilloscope's display section.
Details controls and settings for the vertical channels of the oscilloscope.
Details controls and settings for the horizontal system of the oscilloscope.
Details controls for managing cursors for oscilloscope measurements.
Describes how to display a normal sweep in non-store mode.
Describes how to display a magnified sweep in non-store mode.
Describes how to display magnified and unmagnified sweeps alternately.
Describes how to display signals in X-Y mode in non-store.
Describes how to display a single sweep in single sweep trigger mode.
Discusses controlling vertical aspects of signals using the VERTICAL section controls.
Discusses controlling horizontal aspects of signals using the HORIZONTAL section controls.
Discusses controls and connectors for manipulating signal triggering aspects.
Discusses cursor control functions for signal measurements and analysis.
Discusses storage control functions and switches located on the front panel.
Discusses SETUP functions and MENU function for configuring the oscilloscope.
Discusses AC power connections, fuse holder, and power cord receptacle for the oscilloscope.
Discusses communications interface connections and external clock input function on the rear panel.
Explains the CRT Readout System providing alphanumeric display of information on the screen.
Guides on selecting, connecting, and compensating probes for various applications.
To Next Page
