Tektronix 2212 User Manual

Setup
® SA VE Setup Switch
When you press the SA VE Setup switch, you save the front
panel setup in the memory for later use. The last stored front
panel set up is overwritten.
The saved front panel setup is retained in memory even after
the instrument is switched off.
@ RECALL Setup Switch
Pressing the RECALL button recalls the last stored front
panel setup from the memory.
@ MENU
When you press the RECALL switch and the SA VE switch
simultaneously, the MENU function is displayed on the crt
screen (See Figure 5-8 on page 5-45). Pressing the RECALL
and SA VE button again, will result in leaving the MENU and
return to signal display (indicated as "exit <menu>" on the
menu).
Names of menu lines are in lower case, and parameters on the
menu lines are in upper case. Menu lines outside the dotted
lines are the fixed part of the menu and inside the dotted lines
are the variable part.
Types
If you have a standard instrument, only the Parallel Printer
(I/O Port) HARDCOPY menu (see Figure 5-8) is available.
You can have a 2212 configuration with one of the next four
different menus:
1. The HARDCOPY menu is standard for every 2212.
2. The OTHER menu is for future expansion.
3. The GPIB menu is added to a 2212 with a GPIB
interface option (OptionlO).
4. The RS232 menu is added to a 2212 with an
RS-232-C interface option (Option 12).
2212 User Manual 5 - 43

Tektronix 2212 Specifications

General

Brand	Tektronix
Model	2212
Category	Test Equipment
Language	English