Tektronix 2205

Applications
If the amplitude measurement is critical or if the
trace is thick (because of hum or noise on the
signal), a more accurate result can be obtained
by measuring from the top of a peak to the top of
a valley. This will eliminate trace width from the
measurement.
8, Calculate the peak-to-peak voltage, using the following for¬
mula:
vertical VOLTS/DIV
Vp-p = deflection x setting
(divisions) (10X Probe)*
*}f a 1X probe is being used for the measurement, use the
IX VOLTS/DIV setting.
3-2
2205 Operator’s