Tektronix 2205 - Page 89

Repackaging For Shipment
If this instrument is to be shipped by commercial transportation,
it should be packaged in the original manner. The carton and
packaging material in which your instrument was shipped to you
may be retained for this purpose.
if the original packaging is unfit for use or is not available, re¬
package the instrument as follows:
1. Obtain a corrugated cardboard shipping carton having inside
dimensions at least six inches greater than the instrument
dimensions and having a carton test strength of at least 275
pounds.
2. If it is to be shipped to a Tektronix Service Center for service
or repair, attach a tag to the instrument showing the follow¬
ing: Owner (with address), name of the person at your firm
who can be contacted, complete instrument type and serial
number, and a description of the service required.
3. Wrap the instrument with polyethylene sheeting or equivalent
to protect the outside finish and to prevent entry of packing
materials.
4. Cushion the instrument on all sides by tightly packing dun¬
nage or urethane foam between the carton and the instru¬
ment, allowing three inches on each side.
5. Seal the carton with shipping tape or with an industrial sta¬
pler,
6. Mark the address of the Tektronix Service Center and your
return address on the carton in one or more prominent loca¬
tions.
2205 Operator’s
B-1