Do not operate without covers. Do not operate this product with covers or
panels removed, or with the case open. Hazardous voltage exposure is
possible.
Avoid exposed circuitry. Do not touch exposed connections and
components when power is present.
Use only specified replacement parts.
Replace batteries properly. Replace batteries only with the specified type
and rating.
Recharge batteries properly. Recharge batteries for the recommended
charge cycle only.
Do not operate in wet/damp conditions. Be aware that condensation may
occur if a unit is moved from a cold to a warm environment.
Do not operate in an explosive atmosphere.
Keep product surfaces clean and dry. Remove the input signals before
you clean the product.
Probes and test leads
Connect and disconnect properly. Connect the probe output to the
measurement product before connecting the probe to the circuit under
test. Disconnect the probe from the circuit under test before
disconnecting the probe from the measurement product.
Do not connect a current probe to any wire that carries voltages,
currents, and frequencies above the current probe rating.
Inspect the probe and accessories. Before each use, inspect probe and
accessories for damage (cuts, tears, or defects in the probe body,
accessories, or cable jacket). Do not use if damaged.
Important safety information
viii A622 Instructions
To Next Page
Loading...
Need help?
General
