Trigger Setup
8. If you are setting up an SPI trigger and have
made a Trigger On selection of MOSI or
MISO, push the lower-bezel Data button, push
the side-bezel MO SI (or MISO) button, and
enter the data parameters of interest with
multipurpose knobs a and b.
Then push the Number of Bytes button and
enter the num ber of bytes with multipurpose
knob a.
If you select MOSI & MISO, p ush the
lower-bezel Data button and enter the
parameters of interest in the side-bezel menus.
126 DPO3000 Series Oscilloscopes User Ma nual
To Next Page
Loading...
