Tektronix DPO3000 Series - Using Reference Waveforms

Analyze Waveform Data
Using Reference Waveforms
Create a reference waveform to store a waveform. For example, you might do this to set up a standard against which to compare
other waveforms. To use the reference waveforms:
NOTE. 5 M referen ce waveforms are volatile and not saved when the oscilloscope power is turned off. To keep these waveforms,
save them to e xternal storage.
1. Push Ref R. This brings up the lower-bezel
reference menu.
2. Use the resulting lower-bezel menu selections
to display or select a refe rence waveform.
(R1) |
(On)
3-May-07
(R2) |
(Off)
(R3) |
(Off)
(R4) |
(Off)
DPO3000 Series Oscilloscopes User Manua l 187