Get Acquainted with the Instrument
6. Device. UsetheUSB2.0Highspeed
device port to control the oscilloscope
through USBTMC or GPIB with a
TEK-USB-488 Adapter. The USBTMC
protocol allows USB devices to
communicate using IEEE488 style
messages. This lets you run your GPIB
software applications on USB hardware.
7. Host. Use the USB 2.0 Full speed host
ports (one on the rear-panel and one on
the front) to take advan tage of USB flash
drives, keyboards, and printers.
8. Power input. Attach to an AC p o w er line
with integral safety groun d. (See p age 8,
Operating Considerations.)
DPO3000 Series Oscilloscopes User Manua l 75
To Next Page
Loading...
