Tektronix DPO3000 Series User Manual

Acquire the Signal
2. Push Default Setup.
3. Select the input c hannel b y push ing the
front-panel but tons.
NOTE. If you a re using a probe that does not
supply probe encoding, set the attenua tion
(probe factor) on the o scilloscope vertical menu
for the channel to match the probe.
4. Push Auto set.
DPO3000 Series Oscilloscopes User Manua l 77

Tektronix DPO3000 Series Specifications

General

Brand	Tektronix
Model	DPO3000 Series
Category	Test Equipment
Language	English