Tektronix FG 5010 User Manual

П
П
П
П
11
П
П
П
n
П
n
C
Coaxial - Type , End - Lead Connectors
Replacement of the coaxial type end lead connectors re
quires special tools and techniques ; only experienced main
tenance
personnel
should attempt to
remove or
replace
these
connectors .
Damaged cable should be
repaired or re
placed as a unit . For cable part numbers , see the Replace
able Mechanical Parts list .
An alternative solution is to refer the replacement of the
defective connector to your local Tektronix Field Office or
representative . Figure 7-1 gives an exploded view of a co
axial
end lead
connector
assembly .
} ] ]
19
CABLE
EYELET
RECEPTACLE
SOCKET
RECEPTACLE
HOLE
SOCKET
HOLE
2815-16 (
C1986-71 )
Fig . 7-1 . Coaxial end lead connector assembly .
Circuit Board Pins
A circuit
board pin
replacement
kit
(
including
necessary
tools
, instructions
, and
replacement pins with
attached
fer
rules ) is available from Tektronix , Inc .; refer to the Replace
able Mechanical Parts list for ordering information . Use care
when replacing pins on multilayer boards to avoid damage
to the boards .
To replace a damaged pin , first disconnect any pin con
nectors . Then unsolder the damaged pin and pull it from the
board with a pair of pliers , leaving the ferrule ( see Fig . 7-2 ) in
the circuit board , if possible . If the ferrule remains in the
circuit board , remove the spare ferrule from the replacement
pin
and press
the new pin
into the hole
in the
circuit board .
If
the ferrule is removed with the damaged pin , clean out the
hole using a solder - removing wick and a scribe . Then press
the replacement pin , with attached spare ferrule , into the
circuit board .
B
Maintenance - FG 5010
PROPER
PLACEMENT OF
FERRULES IN
CIRCUIT BOARD
n
REPLACEMENT
PIN
SPARE
FERRULE
2815-17 (
C1967-5 )
Fig
. 7-2 .
Exploded view of circuit
board pin
and ferrule
.
Position the replacement pin in the same manner as the
original .
Solder the
pin to
the
circuit board
on
each side of
the board . If the original pin was bent at an angle to mate
with a connector , carefully bend the new pin to the same
angle .
Replace
the pin
connector
.
7-3

Tektronix FG 5010 Specifications

General

Brand	Tektronix
Model	FG 5010
Category	Portable Generator
Language	English