Tektronix MSO4000B Series Technical Reference

Performance Verification
c. Push the OK Add M
easurement side-bezel button.
d. This will provide a mean V
p-p
of the signal. Call this value V
in-pp
.
e. Enter this val
ue in the test record.
9. Set the Horizontal Scale to 4nsper division.
10. Adjust the s
ignal source to the maximum bandwidth frequency for the
bandwidth and model desired, as shown in the following worksheet.
11. Record the peak-to-peak measurement as follows :
a. View the mean V
p-p
of the signal. Call this value V
bw-pp
.
b. Enter this value in the test record.
NOTE. For more information on the contents of this worksheet, refer to the
bandwid
th specifications. (See Table 1 on page 2.)
Table 15: Maximum bandwidth frequency worksheet
All 1 GHz Models
(MSO4104B, DPO4104B, MSO4104B-L, DPO4104B-L, MSO4102B-L, DPO4102B-L,
MSO4102B, and DPO4102B)
Impedance Vertical Scale Maximum b andwidth
5 mV/div — 1 V/div 1 GHz
2 mV/div — 4.98 mV/div
350 MHz
50 
1 mV/div — 1.99 mV/div
175 MHz
2 mV/div — 4.98 mV/div
350 MHz
1 mV/div — 1.99 mV/div
175 MHz
500 MHz model
(DPO4054B)
5 mV/div — 1 V/div
500 MHz
2 mV/div — 4.98 mV/div
350 MHz
50 
1 mV/div — 1.99 mV/div
175 MHz
350 MHz model
(DPO4034B)
2 mV/div — 1 V/div
350 MHz
50 
1 mV/div — 1.99 mV/div
175 MHz
100 MHz model
(DPO4014B)
50 ,1M 1 mV/div — 1 V/div
100 MHz
1
For MSO4104B, DPO4104B, MSO4104B-L, DPO4104B-L, MSO4102B-L, DPO4102B-L, MSO4102B, and
DPO4102B models bandwidth verification, use 500 M Hz, rather than 1 GHz, on the 5 mV/div vertical scale.
12. Use the values of V
bw-pp
and V
in-pp
that you entered in the test record to calculate
the Gain at bandwidth with the following equation:
MSO4000B and DPO4000B Series Specifications and Performance Verification 67

Tektronix MSO4000B Series Specifications

General

Brand	Tektronix
Model	MSO4000B Series
Category	Test Equipment
Language	English