Tektronix TBS1052B-EDU User Manual

USB device port
You can use a USB cable to connect the oscilloscope to a PC. The USB Device
port is on the rear of the oscilloscope.
USB Device port
Installing the PC communications software on a PC
Before you connect the oscilloscope to a PC with Tektronix OpenChoice PC
Communications Software, you must download that software from
www.tektronix.com/software and install it on your PC.
CAUTION.
If you connect the oscilloscope to your PC before you install the
software, the PC will not recognize the oscilloscope. The PC will label the
oscilloscope as an Unknown Device and not communicate with the oscilloscope.
To avoid this, install the software on your PC before you connect the oscilloscope
to your PC.
NOTE.
Be sure you have installed the latest version of PC Communications
software.
Software for your oscilloscope is available through the Software finder on the
Tektronix web site.
To install the PC Communications software, follow these steps:
1. Run the OpenChoice Desktop software on the PC. The InstallShield wizard
appears on the screen.
2. Follow the on-screen directions.
3. Exit the InstallShield wizard.
USB flash drive and device ports
68 TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual

Tektronix TBS1052B-EDU Specifications

General

Brand	Tektronix
Model	TBS1052B-EDU
Category	Test Equipment
Language	English