Performance Tests
Performance Verification
4Ć36
Check Delay Between Channels
Equipment Required: $ #+#1('+$/ "," )$1-, $(*%(
*# %$ &()%$ W, %." " *# %$ W *(#$*%(
*# $ +"1$&+*1%+&"( *#
Prerequisites: See page 4Ć15.
Procedure:
+) * ,(*" &%)*%$ !$% *% (&%)*%$ $/ $$"
-" %$ *) ! % % )% $,"*) * *)*
Install the test hookup and preset the instrument controls:
Initialize the front panel;
H ()) ),("" SETUP
H ()) * #$1#$+ +**%$ Recall Factory Setup
H ()) * )1#$+ +**%$ OK Confirm Factory Init
Modify the initialized frontĆpanel control settings:
H % not +)* * ,(*" &%)*%$ % $/ $$" +($ *)
&(%+(
H * * %(0%$*" SCALE *% &)
H ()) SHIFT *$ ACQUIRE MENU
H ()) * #$1#$+ +**%$ Mode $ *$ &()) * )1#1
$+ +**%$ Average 16
Hook up the testĆsignal source:
H %$$* *(%+ W &()%$ %." " %""%- /
W *(#$*%$ * )$ -, %+*&+* % #+#1('+$/
)$ -, $(*%( *% +"1$&+* %+&"( +( 1
Medium
Frequency
Sine Wave
Generator
Dual Input Coupler
50 W Terminator
+*&+
*
50 W Cable
Figure 4Ć10:ăInitial Test Hookup