Removal and Installation Procedures
TDS 520A, 524A, 540A, & 544A Service Manual
6Ć41
Reinstallation:
! #'#$ !## $%"$ %#!& '#$ % #!' $%#&*
%! $ ! $%" %! # $% % ! ## !#
NOTE
Be sure to arrange the coax cable around the post as shown in
Figures 6Ć16 and 6Ć17. Failure to do this may impair performance.
Also, when plugging in the digital bus boards, 1 and 3 in Figure
6Ć18, make sure that they remain plugged in on both ends.
% "#!&#$ A14 D1 Bus and Power Cables " * A23
SerPar Board " * Rear Cover and Cabinet " * %!
!"% #$$) ! % !$!$!"
! $&# % ! ## $ (!# !##%) "#!# % DiagĆ
nostics "#!&# ! " *
To Next Page
Loading...
Need help?
General
